How To Operate
How to operate the triple chuck tube laser machine
Gas Installation
Choosing which gases to install on the tube laser cutting machine
Limit Switches Installation
Check Feeding Chuck (1st chuck) Homing Switch
Check Middle Chuck (2nd chuck) Homing Switch
Check Third Chuck (3rd chuck) Homing Switch
Check Material Switch
Check Middle Chuck (2nd chuck) Homing Switch
Check Third Chuck (3rd chuck) Homing Switch
Check Material Switch
Hose System Installation
Chiller Connections
Lift Cylinders Connections
Common Unloader Connections
Linear Rail Oil Connections
Cooling Air For Cutting Head Connections
Gauges and Regulators and Filters Connections
Lift Cylinders Connections
Common Unloader Connections
Linear Rail Oil Connections
Cooling Air For Cutting Head Connections
Gauges and Regulators and Filters Connections
Electrical Installation
All electrical connections and requirement for installation
Changing The Chuck Size
All chucks are 2 stage chucks. This means if you process small materials, you have to set your chucks to accommodate small materials. Likewise, if you want to process large materials, you have to change all the chucks to hold the larger materials.
Electrical Connections During Installation
How to install the electrical cables and wires during installation
Compressed Air Hose Connections
How and where to hook up the hoses for the lifting supports and common unloaders and also for cooling the laser head. Note, for cooling the laser head, make sure to have a separate regulator with air filter because the pressure needed for cooling the laser head is between 20-30PSI. For the lifts and unloaders, you will need 100PSI and could be set on the filters supplied with the machine.
Turning Off The Tube Laser Machine
How to turn off the triple chuck tube laser machine properly
Chucks Operations From Remote
How to clamp and unclamp all chucks from the remote pendant